Chapter 3 web management for print server, 1 configuring print server for tcp/ip, 2 connecting to the print server – NETGEAR PS100 User Manual
Page 20
NetGear Print Server Manual
11
Chapter 3 Web Management for Print Server
• This chapter applies to all NETGEAR Print Server models except
o
Macintosh printing with AppleTalk does not apply to PS101
o
Linux/Unix and Novell Netware printing do not apply to PS101 and PS111W
o
Wireless applies to PS111W only
The web browser interface provides an easy way to configure the print server in a TCP/IP network.
You can configure your NETGEAR PS100 Series Print Server using any web browser such as
Microsoft Internet Explorer or Netscape Navigator.
This chapter contains information about configuring your NETGEAR PS100 Series Print Server using
the print server's browser interface. Please refer to the next following chapters for setting up your
printing system.
3-1 Configuring Print Server for TCP/IP
Using a web browser to configure a NETGEAR Print Server requires both the print server and the host
workstation that the web browser runs on to be configured for TCP/IP.
NETGEAR PS100 Series Print Server is set with the factory setting for DHCP environment, which
means if you have a DHCP server (most recent broad band routers have provided this feature), PS100
Series will get its own IP address settings for TCP/IP.
To know the print server’s IP address, press and hold RESET button for two seconds. The printer will
print out the print server status report, where it includes the IP address information.
3-2 Connecting to the Print Server
In order to configure the print server over the browser interface, your PC workstation must have a web
browser program installed such as Microsoft Internet Explorer or Netscape Navigator. Free browser
programs are available for Windows, Macintosh, or Unix/Linux.
1. Start your Web Browser
2.
In the Address box, enter HTTP:// followed by the IP Address of the print server. e.g.
http://192.168.0.21
Alternatively, the IP address of the print server can be found under "Device Information" in the "Control"
menu of the NETGEAR Print Server Administration Program.
3. You will then be prompted for the password. If no password has been set, just press ENTER.
4. Use the menu selections listed on the left of the screen to move about.