NETGEAR PS100 - Manual (Page 26)

NetGear Print Server Manual
17
AppleTalk
The NETGEAR Print Server supports AppleTalk (EtherTalk), PAP, ATP, NBP, ZIP and DDP
protocols, enabling Apple computers on the network to view and use the Print Server as a regular
AppleTalk printer.
The NETGEAR Print Server is enabled for AppleTalk printing by default. Further AppleTalk
configuration may be configured through a web browser if the print server is configured for IP access.
If the Print Server is not configured for IP access, configuration of the Printer Server for AppleTalk
may be performed through the Print Server Admin program on Windows for Apple machines. Figure
3-4 shows the AppleTalk configuration screen and the following table describes it fields.
Figure 3-4 AppleTalk Configuration Screen
Apple Talk Configuration Fields
AppleTalk Zone The AppleTalk zone that the print server will appear in. To put the print server in the default AppleTalk
zone of the AppleTalk network the print server is connected to, enter a single asterisk.
Printer Type
These are text fields, used to describe the printer driver used for each port. Currently the only printer
driver supported for AppleTalk is LaserWriter.
Communication
Protocol
Sets whether the port uses ASCII or Binary Communication Protocol. Binary communication is faster than
ASCII. The default is Binary.
Save
Cancel
Buttons
Save:
After the configuration, click on ‘Save’ button to save the value permanently.
Cancel:
If changed something that is not good, click on ‘Cancel’ button will load the value back from the print
server. No modification will be made.