Nortel Networks Nortel Secure Router 4134 - Manual (Page 25)

Verifying the Telnet connection 25
save local
—End—
Enabling FTP, TFTP, and Telnet
The default configuration for the Secure Router 4134 includes FTP, TFTP,
and Telnet servers disabled. You can enable any and all of these servers to
allow this type of access to the Secure Router 4134.
Prerequisites
• You must assign an IP address to the Secure Router 4134.
Procedure steps
Step Action
1 To access configuration mode, enter:
configure terminal
2 To enable the FTP service, enter:
ftp_server
3 To enable the TFTP service, enter:
tftp_server
4 To enable the Telnet service, enter:
telnet_server
—End—
Verifying the Telnet connection
Verify the Telnet connection to ensure that users can successfully access
the Secure Router 4134 using remote access.
Prerequisites
• The IP address of the management interface on the Secure Router
4134 must be configured.
• You must have the IP address of the management interface on the router.
• You must have a terminal or workstation connected to the Ethernet LAN.
Nortel Secure Router 4134
Commissioning
NN47263-302 01.02 Standard
10.0 2 August 2007
Copyright © 2007, Nortel Networks
.