Viewing chassis status, Viewing interface module configuration, Checking the system for alarms – Nortel Networks Nortel Secure Router 4134 User Manual

Page 39

Advertising
background image

Checking the system for alarms

39

Viewing chassis status

Use the procedure in this section to view summary information about the
Secure Router 4134 chassis, including its operational status. After you
install interface modules, you can use the

show chassis

command to

verify that the Secure Router 4134 recognizes the modules.

Procedure steps

Step

Action

1

To view summary information about the Secure Router 4134, enter:

show chassis

—End—

Viewing interface module configuration

Use the procedure in this section to quickly check the state and configuration
of installed interface modules.

Procedure steps

Step

Action

1

To view the configuration of interface modules installed in your
Secure Router 4134, enter:

show module configuration all

2

To view the configuration of individual interface modules, enter:

show module configuration [t1|e1|ct3|

serial|hssi|t3] <slot/port>

—End—

Checking the system for alarms

The Secure Router 4134 reports alarms when it detects irregular conditions
in incoming signals to the interface modules. Use the

show module

alarms

command to quickly check for any irregularities.

Procedure steps

Step

Action

1

To view the current alarms for any T1 WAN link on the Secure
Router 4134, enter:

show module alarms t1 <slot/port>

Nortel Secure Router 4134

Commissioning

NN47263-302

01.02

Standard

10.0

2 August 2007

Copyright © 2007, Nortel Networks

.

Advertising