Configuring ftp users, Pinging a device, Prerequisites – Nortel Networks Nortel Secure Router 4134 User Manual
Page 36
36
Commissioning configuration procedures
Configuring FTP users
Procedure steps
Step
Action
1
To access configuration mode, enter:
configure terminal
2
To configure an FTP user, enter a user name:
ftp_user <username>
3
At the prompt, enter a password for the FTP user:
Please enter new password:
<password>
4
At the prompt, re-enter the password:
Please re-enter password:
<password>
If you entered the password correctly, the Secure Router returns a
message indicating a successful configuration:
password is set
—End—
Pinging a device
Ping a device to verify the connection between the Secure Router 4134 and
that network device. If the network device sends a ping reply, a message
indicates that the specified IP address is alive and can communicate with
the router. If the router does not receive a reply, the message indicates
that the address is not responding.
Prerequisites
•
You must physically connect the Secure Router 4134 to the network.
•
You must physically connect the specific network device to the network.
Procedure steps
Step
Action
1
Ping the network device:
ping <ipaddr>
—End—
Nortel Secure Router 4134
Commissioning
NN47263-302
01.02
Standard
10.0
2 August 2007
Copyright © 2007, Nortel Networks
.