Network Technologies USBV-x - Manual (Page 20)

NTI UNIMUX SERIES USB KVM SWITCH
16
The list below describes the functions available in the Edit User mode:
Function: Keystroke:
Add a character to user name string,
password string, or verify password
string, whichever is selected
Switch sequentially between the
User Name edit box, Password
edit box, Verify Password edit
box, and User Access List
Navigate through User Access
List when it is active
Toggle access rights (check/
uncheck) of the highlighted
port in the User Access List
Save the edited configuration.
Administrator will be prompted for
a Yes or No confirmation
Go back to User Name List menu
NOTE: To delete a user from the User Name List, use either the <Delete> key or the <Backspace> key to remove
characters, not the <Spacebar>. Using the <Spacebar> will overwrite the characters with spaces and retain the
user configuration in the User Name List.
Alternate Command Hot Key
To enable the administrator to assign a key in addition to the < ` > (accent key) to use with < Ctrl > to enter into OSD Command
Mode, an Alternate Command Hot Key option is provided. The default factory setting for this option is <`> (disabling the option).
To select an Alternate Command Hot Key, press <
X > from Administration Mode menu (page 14). A window will open and the
administrator will be prompted to press a key. After pressing the key, a confirmation message will appear. The administrator
should press <
Y > (Yes) to validate the key as the Alternate Command Hot Key, or < N > (No) to select another key. Pressing
< Esc > will return to the Administration Mode menu.
Only the administrator is allowed to set or change the Alternate
Command Hot Key. This function must be set individually for each
of the USB User Device ports on the UNIMUX USBV-x USB KVM
switch .
Note: The Alternate Command Hot Key does not replace the
<`> (accent) key, it just works as another way to enter into
Command Mode. After setting it, the user can enter into
Command Mode either with <
Ctrl > + < ` > or with < Ctrl > +
<Alternative Command Hot Key> combination. To disable it,
the administrator should set <
` > as the Alternate Command
Hot Key.
Figure 15- Alternate Command Hot Key
Tab
(Spacebar)
Enter
(If Password string and Verify Password string
are different, this command will have no effect,
enabling the administrator to correct the password)
Esc
Shift
or
A-Z
(Type any upper or lower case
alphabetical or numeric character) + A-Z
0-9
or