Installing a pxi mxi-3 card, Figure 2-1. installing the pci mxi-3, Installing a pxi mxi-3 card -3 – National Instruments 8330 Series User Manual
Page 14: Figure 2-1, Installing the pci mxi-3 -3
Chapter 2
Installation
© National Instruments Corporation
2-3
PXI-PCI 8330 Series User Manual
8.
Replace the computer cover.
Figure 2-1. Installing the PCI MXI-3
Installing a PXI MXI-3 Card
Follow these steps to install the PXI MXI-3 in your PXI or CompactPCI
chassis.
1.
Turn off your PXI or CompactPCI chassis, but leave it plugged in while
installing the PXI MXI-3 card. The power cord grounds the chassis and
protects it from electrical damage while you install the module.
2.
Select a slot for the PXI MXI-3 card:
•
For use in secondary PXI bus—Choose the controller slot (Slot 1)
of your chassis. This slot must support bus arbitration and bus
mastering. The secondary PXI MXI-3 can operate only in such
a slot.
•
For use in primary PXI bus—Choose any unused PXI or
CompactPCI 5 V peripheral slot except Slot 1. (Slot 1 is reserved
for the system controller.)
Warning
To protect both yourself and the chassis from electrical hazards, leave the chassis
off until you finish installing the PXI MXI-3 card.
1
PCI Bus Slot
2
Cut-Outs
3
PCI Bus Card-Edge Connector
4
PCI MXI-3 Board
1
2
3
4