NetComm NP642 - Manual (Page 33)

NP642 IEEE 802.11g PCI Adapter 33
YML785 Rev1
Customer Information
ACA (Australian Communications Authority) requires you to be aware of the following information and
warnings:
(1) This unit shall be connected to the Telecommunication Network through a line cord which meets the
requirements of the ACA TS008 Standard.
(2) This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick
as set by the ACA. These standards are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio noise
and, if not installed and used in accordance with the instructions detailed within this manual, may
cause interference to radio communications. However, there is no guarantee that interference will
not occur with the installation of this product in your home or office. If this equipment does cause
some degree of interference to radio or television reception, which can be determined by turning the
equipment off and on, we encourage the user to try to correct the interference by one or more of the
following measures:
• Change the direction or relocate the receiving antenna.
• Increase the separation between this equipment and the receiver.
• Connect the equipment to an alternate power outlet on a different power circuit from
that to which the receiver/TV is connected.
• Consult an experienced radio/TV technician for help.
(3) The power supply that is provided with this unit is only intended for use with this product. Do not use
this power supply with any other product or do not use any other power supply that is not approved
for use with this product by NetComm. Failure to do so may cause damage to this product, fire or
result in personal injury.