Ricoh Aficio LD132c - Manual (Page 136)

Troubleshooting
124
6
Changing the Paper Size
Preparation
Be sure to select the paper size
with User Tools and the paper size
selector. If you do not, misfeeds
might occur. See p.56 “Tray Paper
Size: (Tray 1-4)”.
Important
❒ If you wish to change the paper
size set in the LCT(optional), con-
tact your service representative.
Note
❒ Procedures for changing the paper
size differ depending on the tray
(paper tray 1, paper tray 2 or the
optional paper tray units). Make
sure you are following the appro-
priate procedure before you begin.
Reference
For details about paper sizes and
types, see p.165 “Copy Paper”.
Changing the Paper Size of
Tray 1 and 2
AAAA
Make sure the paper tray is not in
use. Then, pull out the paper tray
slowly until it stops.
BBBB
Lower the base panel by pushing
"Push". When paper is set in the
tray, push down on the paper.
CCCC
If paper is loaded in the tray, re-
move it.
DDDD
Set the paper guide lock to the
“unlocked" position.
EEEE
While pressing the release lever,
adjust the side guides to the paper
size.
ZGJS120E
ZGJS130E
ZJKY280J
ZGJS210E
ThemisC1_AE_zentai_pre_FM.book Page 124 Thursday, July 28, 2005 2:13 PM