Loading the battery – Ricoh CAMERA RDC-i500 User Manual

Page 18

Advertising
background image

16

Loading the Battery

Load the rechargeable lithium ion battery (DB-20L) to operate the camera.

Important

Note

• When using the camera for the first time, be sure to charge the battery.

(The battery is not charged when the camera leaves the factory.)

→

P.15 “Charging the Battery”

A

Check that the camera is turned off,
and then open the battery cover by
pressing the catch and sliding it in
the direction shown.

See

• P.24 “Turning On/Off the Camera”

B

Load the battery.

Important

Note

• Do not bring metallic objects into

contact with the battery contact
surfaces or electrical connections.
Electrostatic damage could result.

C

Close the battery cover.

Close the battery cover until it clicks into
position.

●

Shooting and Playback Guidelines

The table below gives the approximate recording and playback times that are
available, as measured under the following test conditions.
[Test conditions]
During shooting: Shoot continuously in a recording mode (shoot at intervals of

30 seconds, without turning the camera off in the middle, with
the flash fired 50%, at an ambient temperature of 20°C (68°F).

During playback: Leave the camera continuously turned on in a playback mode

at an ambient temperature of 20°C (68°F).

Battery Type

Approximate

Approximate

Recording Time

Playback Time

Lithium ion battery DB-20L

50 minutes

60 minutes

(fully charged)

Advertising