Naming a song (song name), Part settings (part) – Roland TD-6 User Manual
Page 88
88
Chapter 5 Editing Songs (SONG Edit)
Naming a Song (Song Name)
You can use up to eight characters when naming a User song.
Press [
] or [
] to move the cursor (under bar) to the
character you want to change, then press [INC/+] or [DEC/-]
to select the character.
The settings screen does not appear when a Preset song is
selected.
• Holding down [SHIFT] and pressing [INC/+] switches
through the following sequence: uppercase alphabet ➝
lowercase alphabet ➝ 0 ➝ ! ➝ space. Holding down
[SHIFT] and pressing [DEC/-] switches through the
sequence in reverse order.
• Holding down [SHIFT] and pressing [
] deletes the
character at the cursor position and closes the resulting
space by shifting forward the characters that follow.
• Holding down [SHIFT] and pressing [
] inserts a space
the character at the cursor position and shifts back the
characters that follow.
fig.05-020_50
SngName (Song Name): 8 characters
The following characters may be used.
fig.lettersai.e
Part Settings (PART)
Set the backing parts (Parts 1–4) and percussion part in each
song.
• Changes made to a Preset song are only temporary, and
when you select a different song, the song reverts to its
predetermined part settings. If you want to save any
changes made to Preset song settings, first copy the song
to a User Song before making the changes (SONG/
COPY; p. 90).
• Settings of parts which have the Song Lock (SONG/
COMMON/Song Lock; p. 87) set to “ON” cannot be
changed. Make the settings after setting this to “OFF.”
For the drum kit part settings, refer to Chapter 1.
1.
Confirm that [CLICK] is not lit.
If this lights, press [CLICK] to extinguish it.
2.
Press [SONG], then [EDIT].
[SONG] and [EDIT] light.
3.
Press [
] or [
] to select the part to be set.
fig.05-021ai.e
4.
Press [ENTER
].
5.
Press [
] or [
] to select the parameter you
wish to edit.
fig.05-022ai.e
6.
Press [INC/+] or [DEC/-] to make the setting.
fig.05-023ai.e
7.
When you finish making settings, press [SONG]
to end the procedure.
space
Part to set
Parameter to set
Value