Roberts Radio CRD-42 - Manual (Page 8)

7
Operating your clock radio
1. Press the On / Standby button to switch on your clock radio. The
display will show "TUNING" for a few seconds.
When first switched on, the radio will be in DAB mode. After each use
the radio will remember the mode used and then switch on in that
mode the next time that it is used
2. If the clock radio has been used before, the last used station will be
selected.
3. If this is the first time that the radio has been used, then the first station
in the list of stations found during scanning will be played. The display
will show the station name on the display.
4. If no signals are found then "OFF AIR" will be displayed and it may
be necessary to relocate your clock radio to a position giving better
reception. You should then carry out a scan to find stations as described
on page 11.
• Your clock radio has a indicator on the display to indicate the
strength of the DAB radio signal being received.
Note: When first switched on, the radio will set the volume to a moderately
high level, in case the broadcast is very quiet. After you have set the volume
using the Volume Up or Down buttons, the radio will remember the setting
that you have applied for the next time that it is used.
1