Roland VS-880EX - Manual (Page 53)

Specify the Input Channel to Which the Effect is to be Applied
6. Press [FADER (EDIT)] several times to let the FADER indicator light
orange .
7. Press the channel 1 [CH EDIT (SELECT)].
8. Press PARAMETER [ ] [ ] until “FX1 Ins =” appears in the display.
9. Rotate the TIME/VALUE dial.
FX1 Ins (Effect 1 Insert Switch)
This sets how the Insert functions. In this case, select “InsertL.”
Off: There is no Insert.
Insert: Inserts in both channels of the stereo effect.
InsertL: Inserts in the left channel of the stereo effect.
InsertR: Inserts in the right channel of the stereo effect.
InsertS: Inserts in the left and right channels of the stereo effect in series.
10. Press PARAMETER [ ].
“FX1 InsSend=” appears in the display.
11. Rotate the TIME/VALUE dial.
FX1 InsSend (Effect 1Insert Send Level)
This adjusts the level of the signal (0–127) sent to the Insert effect.
12. Press PARAMETER [ ].
“FX1 InsRtn=” appears in the display.
13. Rotate the TIME/VALUE dial.
FX1 InsRtn (Effect 1 Insert Return Level)
This adjusts the level of the signal (0–127) returned from the Insert effect.
14. Press PARAMETER [ ] several times until “MIX Pan” appears in the
display.
15. Rotate the TIME/VALUE dial.
MIX Pan
This adjusts the pan setting (L63–0–R63) of the signal sent to the MIX bus and
the RECORDING bus. For now select “L63.”
16. Press the channel 2 [CH EDIT (SELECT)].
17. Repeat the Steps 7–15 to make the settings for Channel 2 as same as those
for Channel 1. However, select “InsertR” and “R63” for Steps 9 and 15,
respectively.
Chapter 3 Multi-Track Recording
53
Chapter 3