Roland VS-880EX - Manual (Page 78)

8. “IN* Link=” (“*” is the displayed input) appears
in the display. Specify the inputs for which you
will turn Channel Link ON. Press the SELECT
(CH EDIT) button of the inputs for which you
wish to turn Channel Link ON, and rotate the
TIME/VALUE dial.
9. Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
10. “IN* to =” appears in the display. Specify which
source is to be recorded on each track. First press
the source input SELECT (CH EDIT) button, then
press the track STATUS button for the track to
which the source is to be recorded.
You can also use the TIME/VALUE dial to select the
recording destination track. If you select “---,” that
input will not be output anywhere (i.e., the sound will
not be heard). If you select “MIX,” the source will be
assigned to a mix bus (i.e., sound will be heard but
will not be recorded).
* Sources that have Channel Link set to “On” cannot be
recorded to tracks on which Channel Link is set to “Off”
with the EZ Routing.
11. Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
12. “IN* Pan =” appears in the display. Adjust the
pan of the source. Press the SELECT (CH EDIT)
button for the input whose pan you wish to
adjust, and use the TIME/VALUE dial. You can
also use the pan knobs on the top panel to adjust
the pan.
* When Channel Link is on, adjust the Offset Balance of the
sources. (p. 151)
13. Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
14. “IN* Level =” appears in the display. Adjust the
level of the source. Press the SELECT (CH EDIT)
button for the input whose level you wish to
adjust, and use the TIME/VALUE dial. You can
also use the channel faders on the top panel to
adjust the level.
* When Channel Link is on, adjust the Offset Level of the
sources. (p. 150)
15. Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
16. “Use EFFECT1 ?” appears in the display. If you
wish to use effect 1, press [YES], and proceed to
step 17. If you do not wish to use effect 1, press
[NO] and proceed to step 31.
17. The effect patch will be displayed. Use the
TIME/VALUE dial to select the effect patch that
you wish to use.
18. Press PARAMETER [ ]. You can return to the
previous screen by pressing PARAMETER [ ].
CONDITION MARKER#
MASTER INPUT TRACK AUX
TIME
48
24
4
0
dB
12
CONDITION MARKER#
MASTER INPUT TRACK AUX
TIME
48
24
4
0
dB
12
CONDITION MARKER#
MASTER INPUT TRACK AUX
TIME
48
24
4
0
dB
12
CONDITION MARKER#
MASTER INPUT TRACK AUX
TIME
48
24
4
0
dB
12
Chapter 5 Storing Mixer Settings
78