RuggedCom RuggedRouter RX1100 - Manual (Page 237)

26. Configuring Layer 2 Tunnels
Revision 1.14.3 237 RX1000/RX1100™
26.2.2. General Configuration Menu
Figure 26.2. General Configuration Menu
This menu configures general settings for the daemon that apply to all supported tunnel configurations.
The Daemon UDP Listen Port field configures port used by the daemon to communicate with other
daemons.
Note
All Layer 2 Tunnel daemons in the network must use the same port number. If the router
employs a firewall, ensure that a hole is opened for each of the remote daemons using this port
number.
The Beacon Interval field configures how often a Round Trip Time (RTT) measurement message is
sent to each remote peer. The interval takes the values “Off” to disable RTT measurement or a time
of 10 – 3600 seconds.
26.2.3. GOOSE Tunnels Menu
Figure 26.3. GOOSE Menu
This menu displays configured GOOSE tunnels. Edit the configuration of an existing tunnel by
following the link under the Ethernet Interface field, or create a new tunnel by clicking Add a new
GOOSE tunnel.