RuggedCom RuggedRouter RX1100 - Manual (Page 99)

11. Configuring PPPoE/Bridged Mode On ADSL
Revision 1.14.3 99 RX1000/RX1100™
The Gateway IP Address field defines the IP address to use as the gateway for sending to other
sites. This is usually the same as the Remote IP Address.
11.2.4. ADSL Statistics
Figure 11.5. ADSL Link Statistics
When at least one logical interface is configured, ADSL Link statistics will be available. These statistics
are available from links on the DDS WAN Interfaces menu.
The Local SNR Ratio is an effective indicator of line quality. SNR values above 40 db correspond to
excellent line quality while values below 10 db result in marginal operation or failure.
11.2.5. Current Routes & Interface Table
The table provided by this command is as described in the Networking menu, Network Utilities sub-
menu. It is also provided here as a convenience.
11.2.6. Upgrading Software
For some customers, access to remote sites in accomplished solely by an ADSL connection. Usually
a software upgrade will stop the system being upgraded, perform the upgrade and then restart it. If
ADSL was upgraded in this way, the upgrade would fail as the ADSL link was taken down. Instead,
ADSL software upgrades modify only the software on the disk. You must schedule a reboot in order
to run the new version of ADSL software.