RuggedCom RuggedRouter RX1100 - Manual (Page 284)

34. Maintaining The Router
Revision 1.14.3 284 RX1000/RX1100™
34.2.2.3. Change Alert Definition
Figure 34.5. Change Alert Definition Menu
This menu allows you to change an existing alert definition entry.
The Codepoint is the key part of the alert definition entry and does not allow to be changed.
The Category configures which category the alert definition entry belongs to.
The Name configures the name of the alert definition which will be displayed by Webmin, login or
email forwarder when an active alert exists.
The Subsystem configures which subsystem the alert definition entry belongs to.
The Severity configures the severity level of the alert. The severity level is sorted from highest priority
to lowest priority.
The Alarmable configures whether the matched alert should trigger the critical relay and alarm LED
on the LED panel of the router.
The Enabled configures whether the alert system should monitor and record matched active alert. If
Enabled is not checked, matching active alert will be ignored.
The Renotify Interval configures how often should the matched active alert be notified according to
alert filter configuration setting. If it is disabled, no notification will be forwarded.
The Type configures type of the alert definition entry. There are three types available: Simple, Shell
and RMON. Currently only the first two types are supported. If users choose Shell type, they should
complete parameters under Parameters for Shell table.
The Parameters for Shell table allows user to configure additional parameters if the alert definition
entry type is Shell.