10 adjusting the picture orientation, Adjusting the picture orientation, Pre l iminar y – Runco CINEWIDETM VX-3000D User Manual
Page 67
VX-3000d Series Installation/Operation Manual
51
PRE
L
IMINAR
Y
3.10
Adjusting the Picture
Orientation
By default, the VX-3000d is configured for a “floor/front” installation, in which the projector
is installed upright and in front of the screen. If it is installed behind the screen and/or
mounted on a ceiling, you must change the picture orientation. To do this:
1.
On the DHD Controller remote control or front panel, press MENU.
2.
Select Service from the Main Menu and enter the Service Menu passcode.
3.
Select Display Device from the Service Menu.
4.
Select Configure from the Display Device menu, then select Installation.
5.
Select Orientation, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match
the installation method.
3.11
Installing and
Adjusting the
CineWide Anamorphic
Lens
If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
Runco offers two types of anamorphic lenses for its CineWide projectors: prismatic and
cylindrical.
• The prismatic lens compresses the height of the image (as opposed to stretching the
width) to achieve a 2.35:1 aspect ratio with a 1.78:1 display device.
• The cylindrical anamorphic lens has a larger aperture than the prismatic lens. It
stretches the width of the image to achieve a 2.35:1 aspect ratio with a 1.78:1 display
device. Two, cylindrical anamorphic lens options are available: Rainier II and McKinley.
Although they differ in size and throw distance range (refer to Table 3-3), the installation
procedure for both lenses is similar.
The following models are available with either a prismatic or a cylindrical anamorphic lens:
• VX-3000d/CineWide
• VX-3000d Ultra/CineWide
The following models always use a cylindrical lens:
• VX-3000d/CineWide with AutoScope
• VX-3000d Ultra/CineWide with AutoScope
If you are installing a CineWide projector with a prismatic lens, refer to Whitney
(Prismatic) Anamorphic Lens Installation and Adjustment on page 57. If you are
installing a CineWide projector with a cylindrical lens, continue with the next section.
You must enter a passcode to access the Service menu.
Note
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note