Runco CINEWIDETM VX-3000D - Manual (Page 93)

Operation
VX-3000d Series Installation/Operation Manual 77
PRE
L
IMINAR
Y
• Chroma Delay: use the Chroma Delay control to correct a mis-aligned image from a
Composite or S-Video source. Chroma delay in an image causes color shifts to occur
to the left of the vertical edge transitions, producing artificial shadows or a “halo” effect.
If necessary, adjust this setting to eliminate them.
• Noise Filter: To apply noise filtering to the input signal, select Noise Filter from the
Input Color menu. The Noise Filter is useful for clearing up noisy images from 480i
video sources.
Use the left- or right-arrow buttons to select the desired amount of noise reduction,
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
Save ISF Night/Save ISF Day: Whenever you make a change to the ISF settings, you
should always save it. Select Save ISF Night or Save ISF Day from the Calibration menu to
do this.
Copy/Paste: You can copy and paste settings from one memory location to another.
This gives you a convenient starting point for creating a new preset based on an existing
one, to make the calibration process less time-consuming.
For example, you can use the Copy/Paste feature to:
• Apply settings from HDMI 1 to HDMI 2, or from HD1 to HD2.
• Calibrate an input for 720p source signals, then use those settings for 1080i sources.
• Duplicate ISF Night settings for a given source and signal format and save them in the
Custom 1 memory preset.
To use this feature, select Copy/Paste from the Calibration menu.
• Copy Settings: Select Copy Settings from the Copy/Paste menu to place the settings
for the current input source, signal format (resolution and frame rate) and memory
preset onto a “clipboard,” which is a temporary memory location. When you do, the
message “Settings Copied” briefly appears on-screen. The Copy/Paste menu then
re-appears, indicating the source of the copied settings.
• Paste Settings: To apply the settings on the clipboard to a different input source,
signal format and/or memory preset, do any or all of the following:
• Switch to another DHD Controller input (for example, from HD1 to HD2).
• Change the output signal format at the source (for example, from 720p/60 to
1080i/60).
• Switch to another Memory Preset (for example, from ISF Night to Custom 1).
Then, select Paste Settings from the Copy/Paste menu. If you want to keep these
new settings, you must save them! (Refer to Save ISF Night/Save ISF Day on
page 77 or Memory Presets on page 72.)
Output Shift: The controls in the Output Shift menu are similar to those in the Input
Position menu, except that they change the characteristics of the output signal. These
settings are saved independently for each aspect ratio.
Copy/Paste
Copy Settings
Paste Settings
Copied From:
Input Source HDMI 1
Signal Format 1080p/60
Memory Preset ISF Night
Copied settings are not retained after a power cycle.
Note