Runco CINEWIDETM VX-3000D - Manual (Page 89)

Operation
VX-3000d Series Installation/Operation Manual 73
PRE
L
IMINAR
Y
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
• Gamma
• Color temperature and white balance
To select a memory preset, press or to highlight it and press ENTER.
To save the settings for the current input and display mode to the Custom 1 or Custom 2
memory preset, select it, press
or to highlight Save and press ENTER.
To reset the Custom 1 or Custom 2 memory preset to its factory-default state, select it,
press
or to highlight Reset and press ENTER.
Sleep Timer Select Sleep Timer from the Main Menu to turn off the VX-3000d after a specified interval.
Press
or to select Off, 30 Minutes, 60 Minutes, 90 Minutes, 2 Hours or 4 Hours.
Then, press ENTER.
To save the settings for the current input and display mode to the
ISF Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 77).
Note
Sleep Timer
Î
Off
30 Minutes
60 Minutes
90 Minutes
2 Hours
4 Hours