Adjusting the horizontal (x) lens position, Adjusting the height (y), Pre l iminar y – Runco CINEWIDETM VX-3000D User Manual
Page 70
54
VX-3000d Series Installation/Operation Manual
PRE
L
IMINAR
Y
4.
Select Triggers from the Service menu.
5.
Assign the trigger output to which the lens motor is connected to the Cinema and
Virtual Cinema aspect ratios. This enables the lens motor to move the anamorphic
lens into position (in front of the primary lens) when either aspect ratio is selected.
6.
Select the Cinema aspect ratio to move the anamorphic lens into position, if it isn’t
already. To do this, press CINEMA on the DHD Controller remote control (Figure 2-6),
or press
or
repeatedly with no menus visible on-screen.
Adjusting the Horizontal (X) Lens Position:
1.
Project a white field on the screen.
2.
Loosen the Yaw/X-Adjustment Levers underneath the lens.
3.
Slowly move the anamorphic lens into place (from right to left or vice versa) so that
there are no shadows on either side of the screen:
4.
When the horizontal position is properly set, tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Adjusting the Height (Y): With the white field still on-screen, loosen the
Height/Y Adjustment T-Screws on either side of the lens. Then, slowly move the
anamorphic lens into place so that there are no shadows on the top or bottom of the
screen:
Too Far Right
Too Far Left
Correct position
Too High
Too Low
Correct position