Introduction, Connections, Ultralink configuration – Rose electronic UL-V3 User Manual

Page 14

Advertising
background image

Introduction

The installation assumes the following:

You have an active Ethernet TCP/IP network.

You are connecting the UltraLink to four standalone

computers or a KVM switch.

You have a PC on the network where you will install

the Viewer software.

Connections

Connect the cables to the UltraLink.

The Quad UltraLink consists of four independent

modules. Each one must be setup and configured.

Connect a keyboard, monitor, and mouse to the

appropriate connectors on one of the modules.

Connect a network cable (not provided) to your 10MB

or 100MB Ethernet network port.
(Note: The four network outputs can be connected

to a hub)

Connect the DB25 connectors to a KVM switch or to

four standalone computers with one of the provided
cables. Use the DB25 to DB25 cable to connect to
the KVM ports of a Rose KVM switch. Use the Db25
to HD15-PS/2-PS/2 cable to connect to a standalone
computer or another KVM switch.

Note: These instructions apply for each of the 4 modules

UltraLink configuration

J

Configure the UltraLink IP address

Power on the UltraLink and you will see its

start-up splash screen. Wait for the green screen.

Hit F10 to go to the UltraLink configuration. The

screen changes color from green to gray.

Hit F1 if you want to read some help.

Enter a user ID of “admin” with no password.

Enter the IP address, subnet mask, optional gateway

address, TCP port, and Speed/duplex for this
UltraLink.

Hit F10 to save the network information.

This UltraLink is now active at this address.

Repeat the above procedure for each of the four

UltraLink modules.

Advertising