Rose electronic UL-V3 - Manual (Page 8)

UltraLink Quick Start Guide version 1.2 Copyright Rose Electronics 2002
Introduction The installation assumes the following:
You have an active Ethernet TCP/IP network.
You are connecting the UltraLink to a standalone
computer or KVM switch.
You have a PC on the network where you will install
the Viewer software.
Connections Connect the cables to the UltraLink.
Connect your keyboard, monitor, and mouse to the
corresponding UltraLink rear connectors.
Connect the network cable (not provided) to your
10MB or 100MB Ethernet network port.
Connect the DB25 connector to a KVM switch or to
a standalone computer with one of the provided
cables. Use the DB25 to DB25 cable to connect to
the KVM port of a Rose KVM switch. Use the DB25
to HD15-PS2-PS2 cable to connect to a standalone
computer or another KVM switch.
Note: These instructions do not apply to installation of
the local KVM port, please refer to the UltraLink
manual for instructions on how to connect it.
UltraLink configuration Configure the UltraLink IP address
Power on the UltraLink and you will see its
start-up splash screen. Wait for the green screen.
Hit F10 to go to the UltraLink configuration. The
screen changes color from green to gray.
Enter a user ID of “admin” with no password.
Enter the IP address, subnet mask, optional
gateway address, TCP port, and Speed/duplex.
Hit F10 to save the network information.
The UltraLink is now active at this address
Hit F1 if you want to read some help.
.
D