Ricoh GX200 - Manual (Page 116)

114
V
a
rio
u
s
S
hoo
ting
Fu
nc
tion
s
1
M-Cont (M Multi-Shot)
5
Compose your picture and then press and hold the
shutter release button.
• The camera memorizes the scene while you hold down the shutter
release button.
6
Release your finger from the shutter release button.
• The camera stops shooting and the 16 still images (in the previous 2
seconds) are recorded as one still image.
Caution------------------------------------------------------------------------------------------
• When [Pic Quality/Size] is set to RAW mode, S-Cont and M-Cont are not available.
You can take up to five consecutive shots with Continuous.
• When shooting with S-Cont or M-Cont, the digital zoom is activated even when [Digital
Zoom Img] is set to [Auto Resize] on the setup menu.
• In scene mode, multi-shot is only available when [Zoom Macro] is set.
• The time until image recording is complete may be longer when using the internal
memory.
• The maximum number of images that can be shot in the multi-shot mode is 999.
Note ----------------------------------------------------------------------------------------------
• To return to normal single-image shooting, follow Steps 1 to 3, select [Off] in Step 3,
and press the MENU/OK button.
• In M-Cont mode, if you release the shutter release button within 2 seconds from the
time you first pressed it, the shots from the time you pressed the shutter until you
released it are recorded and the number of consecutive shots will be less than 16.
• The flash is turned off.
• The camera shake correction function cannot be used during multi-shot shooting. If
multi-shot shooting is set while the camera shake correction function is turned on,
E changes to F. (GP.137)
• During multi-shot, the focus and exposure value are locked.
• When [Sequential No.] is set to [On] (GP.213) and the last four digits of the file
number exceed [9999] during multi-shot, a separate folder is created in the SD
memory card and successive pictures taken in multi-shot are stored in this folder.
• When shooting with S-Cont or M-Cont, the ISO setting is fixed at [Auto] even if it is set
to [ISO 64], [ISO 100] or [ISO 200].
• The storage capacity of images in the multi-shot mode depends on the image size
setting.