Radio Shack PRO-2052 - Manual (Page 66)

66
RESETTING THE
SCANNER
You might need to reset the scanner
if:
• the scanner’s display locks up.
• the scanner does not work prop-
erly after you connect power.
• the scanner is dropped or sub-
jected to a physical or electrical
shock.
Caution: This procedure clears all the
information you have programmed
into the scanner. Use this procedure
only when you are sure your scanner
is not working properly.
To reset the scanner, turn it off. Then,
while you hold down
2 and 9 , turn on
the scanner. CLEAr appears for
about 5 seconds while the scanner re-
sets.
Caution: Do not turn off the scanner
while it is resetting.
20-432.fm Page 66 Friday, July 14, 2000 11:30 AM