Output Solutions C I - 8 0 6 0 - Manual (Page 68)

Description of the Individual Menu Items
4-4
S PRINT POS. ADJ.
This function adjusts the print position in the current macro for the six
different paper paths TRACT. L.V-POS, TRACT. L.H-POS,
TRACT.U.V-POS, TRACT. U.H-POS, MANUAL V-POS, MANUAL H-POS or
ASF BIN x V-POS, ASF BIN x H-POS (x = 1 up to 3) to exactly position the
printout in relation to the top edge of the form in use. It is meant to be a
corrective parameter to compensate variations in paper size and pre-printed
material.
This parameter covers a range of:
S
fanfold vertical: -24.0 up to 99.9 in steps of / inch, 1
6
S fanfold horizontal: - 6.0 up to 6.0 in steps of / inch 1
10
S manual or bins vertical: - 1.5 up to 24.0 in steps of / inch, 1
6
S manual or bins horizontal: - 6.0 up to 6.0 in steps of / inch 1
10
where "-" is up the page and "+" is further down the page.
Caution: The set up of PRINT.POS.ADJ. will become effective on the next
page of the form. Therefore, it is recommended to define
PRINT.POS.ADJ. as long as the paper is in the park position and
before starting the print job.
S PAGE LENGTH
Page length is expressed in terms of lines within the range of 1 to 144 lines.
Any page length setting is based on six lines per inch, regardless of the
number of lines per inch selected in the line setting or defined by the
application.
The following table shows the number of lines for the most common paper
sizes:
Paper length in inches
Appropriate setting in no. of lines
4 24
4 / 25 1
6
6 36
8 48
8 / 51 1
2
11 66
11 / 70 2
3
12 (default setting) 72
The page length setting is the basis from which perforation skip, TEAR-OFF
and margins are calculated.
An incorrect page length, therefore, leads to an incorrect perforation skip.