Sylvania 3819LC - Manual (Page 10)

PREPARATION FOR USE
ANTENNA/CABLE
CONNECTIONS
VHF/UHF COMBINED ANTENNA
The VHF/UHF Rod Antenna (not supplied) is detach-
able. Insert the stem of the antenna into the hole on the
upper-back portion of the TV/VCR.
Connect the VHF/UHF Rod Antenna or VHF/UHF
Combination Antenna to the ANT. terminal of the
TV/VCR as shown in the diagram below.
For the best reception, fully extend the VHF/UHF Rod
Antenna and make the necessary adjustments. (Avoid
touching the top section when adjusting.)
NOTE :
Before plugging the Rod antenna into antenna terminal,
check that the pin is not bent. If it is bent, straighten the
pin as illustrated, then plug the pin into antenna terminal.
Bent pin
Cable Plug
(Needs to be straightened) (Straight pin)
NOTE:
The connection of an indoor antenna may not always
give acceptable TV reception.
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor antenna.
CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX
Use this connection if your cable system connects
directly to your TV/VCR without a converter box.
By using this connection you can:
1) Use the TV/VCR remote to select channels
2) Program one or more unscrambled channels for
Automatic Timer Recording.
NOTE: This unit will ONLY record and view the same
channel.
T
T
VHF/UHF Antenna
Rod Antenna
(Not supplied)
ANT
ANT
Flat twin-lead cable
VHF Antenna
UHF Antenna
VHF/UHF
Combiner
(Not
supplied
)
ANT
ANT
From Cable System
75-ohm
Coaxial Cable
(not supplied)
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building as close to the point of cable entry as practical.
[Fig.4]
[Fig.6]
[Fig.5]
Antenna/Cable Connections Continued on the Next Page.
8E21
B7916-01
- 10 - EN