Oricom UHF200 - Manual (Page 29)

29
Operations
* press the PRI/LO button, next 2 digits will be blinking for the next frequency digits.
* Rotary channel switch to select which 2 frequency digits you want.
Briefly press the F/DPX button and Power button to exit.
Automatic programming
1. Press the PWR button to turn the radio on.
2. Briefly press the
F/DUP button and then the Power Button.
* The default Band frequency range will be displayed.
3. Briefly press the
SC/MEM button (OS is displayed).
4. Briefly press the power or channel knob (channel will flash).
5. Turn the power or channel knob until you get to an open frequency.
6. Auto scan will commence in 2 to 3 seconds.
* You will need to repeat steps 4 and 5 until the required frequency has been
located.
7. To store the required frequency, briefly press the ID/CAL button.
8. To exit; repeat step 2.
Factory reset
If the radio's display locks up or stops functioning properly, you might need to
reset your UHF radio.
Caution: this procedure clears all the information you have stored in your UHF
radio.
Before you reset your UHF radio, try turning it off and on again. If your UHF radio
is still not functioning correctly you may need to reset the UHF radio!
While holding the
F/DPX button, turn the UHF radio on. INITI AL will be displayed
for 1 to 2 seconds, the radio will then return to its original display.
MO / TSQ ID / CAL PRI / LO SC / MEM F/ DPX
MENU QUIET ALPHA OS / GS