Nikon 200-400mm f 4G ED AF-S VR II Zoom-Nikkor - Manual (Page 25)

25
Jp
En
De
Fr
Es
Se
Ru
Nl
It
Ck
Ch
Kr
En-01
R145_En_00_25 2010/01/25 19:50
■ Setting the aperture
Use the camera to adjust the aperture setting.
■
Focusing, zooming, and depth of field
Before focusing, rotate the zoom ring to adjust the focal length until the desired
composition is framed. If your camera has a depth-of-field preview (stop-down)
button or lever, depth of field can be previewed through the camera viewfinder.
• This lens is equipped with the Internal Focusing (IF) system. As the shooting
distance decreases, the focal length also decreases.
• The distance scale does not indicate the precise distance between the subject
and the camera. Values are approximate and should be used only as a general
guide. When shooting distant landscapes, depth of field may influence operation
and the subject may appear in focus at a position that is closer than infinity.
• For more information, see p. 200.
■ Using a built-in rotating tripod collar
When using a tripod, attach it to the lens’ tripod collar instead of the camera.
• When holding the camera by its handgrip and rotating the camera with the
lens in its tripod collar, your hand may bump into the tripod, depending on
the tripod in use.
• It’s possible to detach the tripod collar by removing the tripod collar lock
screw. For details on this procedure, contact your nearest Nikon service center
or representative office.
Changing the camera position
Loosen the tripod collar ring fastening screw (1).
Depending on camera position (vertical or horizontal),
turn the lens to an appropriate lens rotating position
index (2) and tighten the screw (3).
■ Using the lens hood
Lens hoods minimise stray light and protect the lens.
Attaching the hood
• Fully tighten the lens hood screw (2).
• If the lens hood is not correctly attached,
vignetting may occur.
• To store the lens hood, attach it in the
reverse position.