Shooting tips and maintenance, Shooting tips and information – Olympus E-5 User Manual

Page 130

Advertising
background image

130

EN

12

Shooti

ng tip

s

and m

a

intenance

12

Shooting tips and maintenance

The camera does not turn on even when a battery is loaded

The battery is not fully charged

• Charge the battery with the charger.

The battery is temporarily unable to function because of the cold

• Battery performance declines in low temperatures, and the charge may not be sufficient to turn on

the camera. Remove the battery and warm it by putting it in your pocket for a while.

No picture is taken when the shutter button is pressed

The camera has turned off automatically

• To save battery power, if there is no operation, the camera goes into sleep mode after a fixed

period of time and the camera stops operating. The camera activates again when you touch the
shutter button or any other button. The camera will turn off automatically if there is no further
operation for 4 hours. The camera will not work until it is turned back on.

g“SLEEP” (P. 108), “4

h TIMER (Auto power off)” (P. 111)

The flash is charging

• When the flash is activated and the

# symbol in the viewfinder is blinking, this indicates that the

flash is charging. Wait for the blinking to stop, then press the shutter button.

Unable to focus

• When the AF confirmation mark in the viewfinder is blinking, it indicates that the camera is unable

to focus using AF. Press the shutter button again.

Noise reduction is activated

• When shooting night scenes, shutter speeds are slower and noise tends to appear in images. The

camera activates the noise-reduction process after shooting at slow shutter speeds. During which,
shooting is not allowed. You can set [NOISE REDUCT.] to [OFF].

g“Noise reduction” (P. 72)

The date and time has not been set

The camera is used with the settings at the time of purchase

• The date and time of the camera is not set when purchased. Set the date and time before using

the camera.

g“Setting the date/time” (P. 14)

The battery has been removed from the camera

• The date and time settings will be returned to the factory default settings if the camera is left

without the battery for approximately 1 day. The settings will be canceled more quickly if the
battery was only loaded in the camera for a short time before being removed. Before taking
important pictures, check that the date and time settings are correct.

Shooting tips and information

s0033_e_00_0_unified.book 130 ページ 2010年11月16日 火曜日 午後5時24分

Advertising