Olympus E-5 - Manual (Page 63)

63
EN
3
Focusing
and sho
o
ting
fu
nct
ions
Setting the focal length
By setting in advance the focal length of the lens, you can
use the image stabilizer function with lenses other than
Four Thirds system lenses. This setting is deactivated
when a Four Thirds system lens is attached.
1
Press the F button when the image stabilizer is
turned on.
2
Use the dial or ac to set the focal length and
press i.
• Choose the value that most closely matches to the one that is printed on the lens.
• You can assign [IS MODE] to the Fn button to use it as a direct button.
x
Notes
• The image stabilizer cannot correct excessive camera shake or camera shake that occurs
when the shutter speed is set to the slowest speed. In these cases, it is recommended that
you use a tripod.
• When using a tripod, set [IMAGE STABILIZER] to [OFF].
• When using a lens with an image stabilization function, turn off the image stabilization
function of either the lens or the camera.
• If [IMAGE STABILIZER] is set to [I.S.1], [I.S.2] or [I.S.3] and you turn off the camera, the
camera will vibrate. This is due to the camera initializing the image stabilizer mechanism.
Without this initialization, the image stabilizer may not be able to achieve the proper effect.
• If the image stabilizer icon blinks in red on the monitor, it indicates a failure of the image
stabilizer function. If you take a picture as is, the composition may be off. Consult your
Olympus Authorized Service Center.
łŖŕŐ łŖŕŐ
j
HD
L F
s0033_e_00_0_unified.book 63 ページ ２０１０年１１月１６日 火曜日 午後５時２４分