Teac W-865R - Manual (Page 22)

22
Synchro Reverse Dubbing (from TAPE I to TAPE II)
5 4 3 3
1 1 2
When you use this dubbing function and a shorter tape reaches
the end of side “A”, it momentarily stops until the other tape
reaches the end of side “A”. Then both tapes automatically
switch over to side “B” and recording and playback re-start
simultaneously.
If TAPE I is shorter than TAPE II:
1. When TAPE I reaches the end of side “A”, TAPE I stops and
TAPE II enters the “blank recording” mode.
2. When TAPE II reaches the end, both TAPE I and ll are reversed
simultaneously. TAPE l starts reverse play and TAPE II resumes
recording.
3. When TAPE I reaches the end of side “B”, both TAPE I and ll
stop simultaneously.
If TAPE I is longer than TAPE II:
1. When TAPE II reaches the end of side “A”, TAPE Il enters the
record-pause mode, while TAPE I continues playback.
2. When TAPE I reaches the end, TAPE I starts reverse play and
TAPE II starts recording .
3. When TAPE Il reaches the end of side “B”, both TAPE I and ll
stop simultaneously.
Insert a cassette tape for playback into the TAPE I
compartment and a cassette tape for recording into the
TAPE II compartment.
Set the REV MODE switch to the two-way (j )
position.
Check the recording direction of both decks.
If the reverse direction indicator (h) lights on the display,
press the PAUSE button followed by the forward play button
(y). Then, be sure to press the stop button (H) to get out of
the pause mode.
< Be careful not to press play button whose arrow points in the
same direction as the indicator. Doing so will start playback.
< You don’t need to adjust the recording level or set the Dolby
NR system, as both depend on the pre-recorded source tape.
3
2
1