Using the remote control unit, Line in and line out jacks, Ac power cord – Teac W-865R User Manual

Page 7

Advertising
background image

ENGLISH

7

LINE IN and LINE OUT jacks

Use the supplied RCA cables to make connections between
this unit and your amplifier. Make sure to connect:

White plug to White jack (L: left channel)
Red plug to Red jack (R: right channel)

<

Plugs must be firmly inserted into the corresponding jacks.
Do not bundle the RCA cables together with the power cord
and speaker cables. Doing so will degrade sound quality or
generate noise.

AC power cord

Plug this AC power cord into an AC wall socket.

<

Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.

<

Hold the power plug when plugging or unplugging the
power cord. Never pull or yank on the power cord.

<

Unplug the power cord when you are not going to use the
unit for some time.

B

A

Using the Remote Control Unit

Cautions when using the remote control unit

<

Point the remote control unit at the remote sensor of the
cassette deck and operate the remote control unit at a
distance of no more than 5 meters. Do not place objects
between the remote control unit and remote sensor.

<

Direct sunlight or very bright light will reduce the sensitivity of
the remote sensor. If this is the case, use the control buttons
on the cassette deck instead of the remote buttons.

<

It is possible that other infrared-ray-sensitive equipment
nearby may malfunction when you operate the remote
control.

Loading batteries into the remote control unit

Remove the lid of the battery compartment, load two “AA”
sized batteries in the indicated directions, and then replace
the lid. When inserting batteries, be sure to observe proper
polarity (+ and –).

If you have to put the remote control unit quite close to the
remote sensor or if any remote buttons do not work, then
the batteries are no longer fit for use and must be
replaced.
Be sure to always replace both batteries at once.

Important Cautions for Handling Batteries

Improper battery use can result in leakage or rupture. Observe
the following instructions:

<

Load the batteries in the correct direction as indicated in the
battery compartment.

<

Do not mix old and new batteries, or mix different types or
brands of battery.

<

Do not heat, disassemble, or throw batteries into fire or
water.

<

Do not store or carry batteries together with other small metal
objects. Doing so can cause battery shorting, leakage or
rupture.

<

Do not try to recharge dry batteries.

<

When the cassette deck is not going to be used for a long
time (more than one month), take the batteries out of the
battery compartment.

<

If leakage into the battery compartment is observed, wipe up
any liquid inside the compartment and load new batteries.

Advertising