Toshiba SG-1800 - Manual (Page 11)

11
Preparation
SETTING UP THE BASE UNIT (WALL MOUNTING)
MOUNTING ON A STANDARD WALL PLATE:
Insert the bracket’s tabs into the
base’s lower tab slots, then press
down on the top of the bracket to
snap it into the clip slots.
• Route the cords through the guides.
• Place the base unit on the posts of the wall plate and push down until it is
firmly seated.
• USE ONLY WITH Supplied AC ADAPTOR (TAC-1700; power source AC
120V, 60 Hz/DC 9V).
NOTES:
• Do not use any outlet controlled by a wall switch.
• If you don’t have a standard wall plate, cut out the template on page 33 and
use it to position two screws (minimum length of 1 3 /
8
inches) into the wall
with the heads protruding about 1 / 4 inch.
INSTALLATION
Raise the antenna.
Flip the switch hook
tab over so the tab
holds the handset.
Telephone Line Cord
Single-Line
Telephone Jack
(RJ11C)
Power Outlet
(AC 120 V, 60 Hz)
AC Adaptor
*SG-1800.qx 7/11/0 7:03 PM Page 11