Toshiba SG-1800 - Manual (Page 16)

16
INSTALLATION
SETTING THE AREA CODE
It is necessary to program your area code so that local calls will be
properly displayed on caller ID.
1
Press . The LCD displays the
following message.
2
Press or to move the pointer to Area
Code.
3
Press .
Enter a 3-digit area code. For example, enter
“615.”
If you enter a wrong number, press
.
4
Press . A beep sounds and the area
code is set.
5
Press . The handset is put in
standby mode.
NOTES:
• Change your area code when you move to another location that has a
different area code.
• When you make a call to a number within your area code, only the last 7
digits of the number are dialed. During call-back, however, the phone will
include the area code from where the call originated when it automatically
redials the number. To avoid this problem, always be sure to set the area
code of your phone so that the phone will automatically exclude the area
code when the incoming code is the same as that of the phone.
FUNCTION
SELECT
DELETE
SELECT
3
FUNCTION
1 Auto Talk:Off
2 CIDCW
:On
3 Area Code:615
1s sAuto Talk:Off
2 CIDCW :On
3 Area Code:
1 Auto Talk:Off
2 CIDCW
:On
3s sArea Code:
1 Auto Talk:Off
2 CIDCW
:On
3s sArea Code:615
FUNCTION
SELECT
Dialpad
*SG-1800.qx 7/11/0 7:03 PM Page 16