Tiger Products Co., Ltd JOHN DEERE 5093E - Manual (Page 35)

ASSEMBLY
Assembly Section 2-3
DRIVESHAFT & FRONT PUMP MOUNTING
Thread the pump drive shaft into the crankshaft adapter.
Slide splined drive shaft coupler onto the pump drive shaft. Install the pump onto the mount-
ing bracket. NOTE: the pump is offset to one direction, the pump should be installed with the off-
set side on top. Install hardware for securing pump to the pump mount, DO NOT tighten.
Install pump and align so that splined coupling can be moved (FREE PLAY) back and forth
by hand. Rotate coupler and check free play every 1/4 turn. Tighten pump mounting bolts in
succession rechecking for spline coupling free play. Remove the pump mounting bracket bolts
one at a time and apply a thread locking agent. Tighten these bolts in succession, again check-
ing for free play in the drive shaft. After all bolts are torqued, the end play on the drive shaft
should be 1/16” to 1/8”, and coupler should move freely with hand pressure. If end play is less
than 1/16”, grind the end of the shaft to achieve the proper end play. If there is more than 1/4” of
end play, return the shaft with specifications for a longer shaft.
CAUTION: DO NOT START THE TRACTOR UNTIL ALL HOSES ARE ATTACHED, TANK
IS FILLED WITH PROPER OIL AND BALL VALVES ARE OPEN! STARTING AT THIS TIME
WILL CAUSE SERIOUS DAMAGE TO THE PUMP.
(ASM-C-0091)
ADJUSTING REAR WHEELS
Raise rear of tractor onto jack-stands. Follow the instructions in the tractor owners
manual for adjusting tires and rims. The back wheels MUST be adjusted to the widest
setting. NOTE: This may require switching the wheels to opposite sides of tractor. Also take
note of any width restrictions when transporting by trailer. (For ease of installation, it is best to
leave the rear wheels removed during installation of the mower.)
(ASM-B-0001)
4WD FRONT TIRE ADJUSTMENT
In order to prevent interference with mounted equipment, the front wheels on a 4WD 5101E
tractor will have to be adjusted to approximately 64” center to center distance as shown below.
Please refer to your John Deere Maintenance Manual to see the correct rim and tire configuration
to achieve this. Double check the wheel spacing after adjustment by oscillating and turning the
tires fully to check for any interference.
(ASM-JD-0069)