Tiger Products Co., Ltd JOHN DEERE 5093E - Manual (Page 39)

ASSEMBLY
Assembly Section 2-7
SWITCH BOX WIRING
Route the green wires and the red wire (with the 10amp fuse) from the switchbox to
the front console panel. Refer to the parts section for wiring diagram to hook up the
switch box. Cover the wires from the switch box with plastic wire wrap provided.
Remove the console panel under the steering wheel to access wires. Locate the
neutral safety brown colored wire. Use a test light or meter to verify this wire is the
neutral safety wire. Cut the brown neutral safety wire and connect the green wires
from the switch box as shown in the wiring diagram.
Run the white and black wire to the solenoid valve. Route the wires through the back
window with the cable control wires. Use the rubber grommet in the window to protect
the wire, and route the wire out of the cab down to the 1/4” hydraulic hoses. Follow
the hydraulic hoses through the wheel well to the front of the tractor.
The black wire from the switchbox should be routed to the auxilary plug.
The wires from the switch box are longer than needed and should carefully cut and
spliced as required. Zip ties should be used to secure the wires to the tractor.
(ASM-JD-0064)
VALVE MOUNTING
Attach the rear valve mounting bracket to the fender of the tractor by removing the
two rear bolts on the left fender and the two rear bolts on the right fender. See illustration
below. Drill the square holes in the fenders to accept 3/8” capscrews. Use the hardware
noted in the parts section to attach the valve mounting bracket to the tractor.
Next, attach the valve mounting plate to the mounting bracket. Align the holes on the
plate to the holes on the bracket. Use the hardware shown in the parts section to attach the
plate to the valve mounting bracket. Finally, place the valve on the valve mounting plate as
shown in the parts section. Align the holes on the valve assembly to the holes on the plate.
Use the hardware provided to secure the valve to the plate. Refer to the parts section for the
placement of the valve and the hardware used. Please handle the lift valve with care. It is
extremely heavy and contains small parts.
(ASM-JD-0065)