Tiger Products Co., Ltd JOHN DEERE 5093E - Manual (Page 49)

ASSEMBLY
Assembly Section 2-17
3-POINT BOOM REST MOUNTING
Install the boom rest onto the 3-point hitch using the pins as shown in the parts
illustration. Adjust the bottom arms so the boom clears the tractor fender (X), adjust the top
link so that the boom saddle is approximately level with the ground. Re-adjust once the boom
is completely installed and operable. Adjust the top link until the boom is properly seated in
the boom rest (Z) and no part of the boom (including hoses) comes into contact with the
tractor cab. Next, using the side turnbuckles, adjust the boom and boom rest all the way to
the right for proper width restrictions. Check your local width regulations before transporting
your mower. You may need to adjust the boomrest for overall height as well (Y).
(ASM-C-0054)
AXLE BRACE MOUNTING
Position the right axle brace under the tractor right hand side. Raise the brace up to the
matching mounting holes in the main fame and rear axle housing. Note the right side brace is
installed on outside edge of the main frame and the left side brace is installed on the inside edge
of the main frame. Pictures below show right side brace installation. Install the clamp plate with
capscrews, washers and nuts as shown in the main frame parts section. Apply Loc-Tite to the
threads and torque to the values noted in the torque chart located in the maintenance section of
this manual.
(ASM-JD-0072) .