Tiger Products Co., Ltd JOHN DEERE 5093E - Manual (Page 50)

ASSEMBLY
Assembly Section 2-18
MAIN BOOM INSTALLATION
Install the boom swivel into the main frame as shown in the parts section using a hoist. Line up holes
in swivel and main frame for large swivel pin and insert pin. Secure with hardware as shown.
Attach the inner end of the main boom to the swivel bracket with the cylinder anchors positioned
upward, and at a right angle to the tractor. Secure it with the horizontal hinge pin. Secure the hinge pin in
the boss with capscrews, etc. (see Parts Section).
Attach the butt end of the main boom cylinder to the swivel with the cylinder pin and roll pins shown in
the Parts Section.
Install the travel lock on the rod end of the main boom cylinder. This should be facing the butt end of
the cylinder after installation.
Install the fittings and hoses to the main boom cylinder per Parts Section.
GREASE HINGE PIN ZERKS ON BOOM AFTER ASSEMBLY, ONCE UNDER LOAD WITH BOOM
ELEVATED AND AGAIN AT REST WITH BOOM SUPPORTED (ASM-C-0013)
DECK ATTACHMENT
Attach the head to the secondary boom using the pins and hardware shown in the parts section
to attach linkages. Install the square tube on the top of the head into the head mount and secure
using the mounting plate and hardware as shown. The mount should be positioned to the left side of
the cutter head. Install the deck pivot cylinder using the pins and hardware also shown in the parts
section.
Connect the fittings and hoses from the pivot cylinder to the small preformed tubes on the boom
arm. Connect the fittings and hoses from the motor to the large preformed tubes on the boom arm.
Connect all remaining hoses from the control valve to the cylinders and / or preformed tubes on the
boom arm. Refer to parts section for diagrams.
Before proceeding to the final preparation step double check the complete
assembly from the main frame to the cutter head against the diagrams in the parts
section for proper placement and assembly of all components.
(ASM-C-0060)