Tiger Products Co., Ltd JOHN DEERE 5093E - Manual (Page 36)

ASSEMBLY
Assembly Section 2-4
POLYCARBONATE SAFETY WINDOW
NOTE: In most cases this should be done before mounting the main frame. Carefully
remove the existing right rear cab window, to be replaced with the matching polycarbonate
window provided.
Clean all of the surfaces around the window opening, once the rear window is removed.
Peel back the protective paper from the area around the window that will contact the window
frame. Apply a bead of urethane window adhesive, supplied in kit, around the window opening.
Carefully position the new window into position. Fill the remainder of the gap around the window
with the adhesive, to finish. Be sure to follow the instructions on the adhesive label when
installing window.
Next, install the upper and lower door hinges along with the existing cab door hinges. To
do this, you will remove the existing hinge hardware and install the existing hardware on the
polycarbonate as shown in the Parts Section. Set the safety screen assembly on the hinges and
attach the door to the tractor frame. Install the brackets with the hardware shown in the Parts
Section. Assemble the rod with the vibration isolator and nuts and attach them to the brackets.
Adjust the vibration isolator on the upper and lower brackets to achieve a good fit with the
window.
Installing a boom mower requires that all right side windows be replaced or
shielded by a lexan safety window.
(ASM-JD-0061)
MAIN FRAME INSTALLATION
With an overhead hoist and / or jack-stands, raise one side of the frame up to the correctly
matching mounting holes. Install capscrews and all other hardware as shown in main frame
parts section to secure the sides of the main frame to the tractor casting, DO NOT tighten at this
time. Remove the capscrews one at a time and apply a thread locking agent. Reinsert the
capscrews and tighten / torque to values noted in the torque chart located in the maintenance
section of this manual.
(ASM-C-0003)