Tiger Products Co., Ltd JOHN DEERE 5093E - Manual (Page 44)

ASSEMBLY
Assembly Section 2-12
SIDE HYDRAULIC TANK INSTALLATION
Install all fittings and tubes into tank and tank filter as shown in the Parts Section illustration.
Insert tank sight glass into front side of tank.
Place the tank in the mounting bracket on the main frame as shown in the Parts Section.
Secure the tank with the tank channel mount by placing the channel mount on top of the tank and
the washers over the holes. Thread the tie bolts through the washers and holes to the threaded
holes on the main frame. Tighten the tank channel mount by using the hex heads on the end of
the tie bolts.
Install the filter gauge into the filter housing so that it points to the rear of the tractor and is
clearly visible to the operator. The tank breather cap is ready for use as the tank is filled. Some
of the for-metioned items may be already installed.
(ASM-MOTOR HYDRO-0001)
WHEEL WELL HYDRAULIC TANK INSTALLATION
Install all fittings and tubes into tank and tank filter as shown in the Parts Section illustration.
Insert tank sight glass onto the tractor side of the tank.
Place the tank in the mounting bracket on the axle brace as shown in the Parts Section.
Secure the tank with the hardware provided.
Install the filter gauge into the filter housing so that it points to the rear of the tractor and is
clearly visible to the operator. The tank breather cap is ready for use as the tank is filled. Some
of the for-metioned items may be already installed.
(ASM-C-0103)
FILLING HYDRAULIC RESERVOIR
Refer to the maintenance section for filling specifications and hydraulic oil requirements.
NOTE: Starting or running your Tiger mower before filling reservoir will cause
serious damage to hydraulic pump.
(ASM-C-0004hydro resrv)
WHEEL SPACERS
When mounting a boom mower, a spacer kit is needed for both rear wheels (part#
06200637). After removing the wheels attach the spacer to the wheel portion of the axle with the
hardware provided. When you are ready to re-attach the wheel, the wheel goes on first then the
reinforcement ring and finally the hardware provided.
(ASM-JD-0099)
INSTALLING O-RING FITTINGS
Installing straight, 45º and 90º O-rings requires that the O-ring and washer be up against the
swivel body. Insert the swivel and turn in until the swivel is pointed in the desired direction and O-
ring contact is made. Hold swivel in set direction with a wrench and turn the O-ring nut away
from the swivel body and carefully tighten.
(ASM-C-0056)
GENERAL HOSE INSTALLATION
Refer to the parts section for detailed information about hoses and fittings for this application.
(ASM-C-0011)