Tiger Products Co., Ltd JOHN DEERE 5093E - Manual (Page 46)

ASSEMBLY
Assembly Section 2-14
Route the hoses through the space between the swivel and the boom mounting
bracket. Connect the hoses to the preformed tubes and move the boom arm to a few feet
from full forward. Assemble the swivel clamp and place the return hose for the motor on
top and the pressure line on the bottom. Place the ¼” hoses in the “C” clamp and add it
to the bottom screw of the swivel clamp. Next, make sure there is enough slack for all
hoses to pivot at the joint where the main boom arm bends in the swivel, as shown in the
next image, and tighten the hoses in the clamp.
Arrange the hoses in the clamp that attaches to the boom mounting bracket as shown
above, with the 1” motor hoses closest to the bracket and the return hose closest to the
boom arm. Pull the hoses snug from the swivel to the mounting bracket clamps, when
main boom is still forward, and tighten the hoses in the clamp.
Make sure the 1” motor hoses do not kink as the boom arm is moved into the stowing
position. If this happens the motor hoses will have to be shortened, because there is too
much hose between clamps.
(ASM-C-0059)