Toshiba TEC MA-1350-1 - Manual (Page 102)

- 36 -
EO1-11126
MA-1350-1 SERIES
PLU
PLU Preset Price Changing
When only changing preset prices of PLUs as part of daily requirements, this operation is quicker than oper-
ating “PLU Table Setting, Changing, or Deletion.”
Condition: Any time outside a sale
Programming Procedure:
NOTE 3
PLU Code max. 4 dig-
its; 1 to 9999
Repeat for other PLUs if necessary.
NOTE 1
ST
New Whole Package
Quantity max. 2 digits;
0 to 99
NOTE 4
For non-SPP PLUs or for no change
of Whole Package Quantity
. . .
New Preset Price
max. 6 digits; 0 to
999999¢
NOTE 2
AT/TL #/NS
NOTES: 1. The PLU Codes must exist in the PLU table file already programmed.
2. If “0” is entered as the New Preset Price, price of $0.00 is set. Neither price setting nor Whole
Package Quantity changing are possible for Open-price PLUs in this operation.
3. For sequentially accessing PLU Codes, the code specification can be omitted.
4. The entry of “New Whole Package Quantity” is possible only for SPP-type PLUs (those
already set with Whole Package Quantity). When the Whole Package Quantity is changed
here, the New Preset Price (i.e., New Whole Package Price) must also be set here.
PLU Preset Price Change using the PLU Preset-code Key:
ST
New Whole Package
Quantity max. 2 digits;
0 to 99
For non-SPP PLUs or for no change of
Whole Package Quantity
. . .
New Preset Price
max. 6 digits; 0 to
999999¢
AT/TL
PLU Preset-
Code Key