Toshiba TEC MA-1350-1 - Manual (Page 70)

- 4 -
EO1-11126
MA-1350-1 SERIES
3. Read and Reset Reports
This chapter describes the operation to take each report and its contents.
• The Read (X) reports allow to read the totals but not clear the memory, while the Reset (Z) reports allow to
read the totals and, at the same time, clear all the resettable totals when the report has been taken.
• The symbol “X” is printed at the top of Read Reports, while “Z” is printed on Reset Reports to indicate the
type of report.
• Reset Report Counter is printed on each Reset Report only.
• The daily report covers data obtained during a certain period on that day until the corresponding Reset
Report was printed, while the periodical report covers data obtained during a certain period defined by the
store.
• When you take a read report, the “R OFF” lamp must be extinguished. If it is illuminated, press the [LOG/
RECEIPT] key to extinguish the lamp. As for a reset report, it can be issued even if the “R OFF” lamp is
illuminated.
Report Name Key Operation Sample
Page
* Financial Read Control Lock: X
* Financial Reset Control Lock: Z
Hourly Sales Read Control Lock: X
Hourly Sales Reset Control Lock: Z
All Department Read (NOTE 2) Control Lock: X
All Department Reset (NOTE 2) Control Lock: Z
Department Gross Profit Read
All PLU Sales Read Control Lock: X
All PLU Sales Reset Control Lock: Z
Zone PLU Sales Read Control Lock: X
Zone PLU Sales Reset Control Lock: Z
* Media Sales and In-drawer Read
* Individual Cashier Read (NOTE 3) Control Lock: X Cashier Signing Method
* Individual Cashier Reset (NOTE 3) Control Lock: Z
Cashier Key Method
Set the required Cashier
Key ON, then
→
→
→
AT/TL 0 1
AT/TL 6
12
13 AT/TL 1 1
→
@/FOR PLU
Zone-start
PLU Code Zone-end
PLU Code
(or , ) #/CID #/NS
→
LOG
RECEIPT
Cashier Code:
1 to 8
→
→
1 AT/TL
14
12 Control Lock: X
→
Control Lock: X AT/TL 2 1
→
PLU
#
14
14
15
Daily Reports
WARNING!
When opening the cash drawer, be careful not to let the drawer hit any person.
CAUTION: Whenever you turn the Control Lock to “Z” position, be sure that you are taking Reset Reports
(final reports) and that the sales data will be cleared by the operation to follow.