Toshiba TEC MA-1350-1 - Manual (Page 9)

- 2 -
EO1-11126
MA-1350-1 SERIES
3. Outline of Preparation Procedure Before Operating the
ECR
This chapter shows the outline of set-up procedure of the ECR before actually starting the ECR operation.
5
4
3
2
1
OFF
REG
X
SET
MGR
-
Z
OFF
REG
X
SET
MGR
-
Z
Remove the cash register from the carton, referring to Chap-
ter 2. Unpacking on page 1. And take out all the parts and
accessories.
Remove the tapes and seals for holding parts or protecting
the register surfaces.
Plug the power cord of the register into a wall outlet. Make
sure that the outlet voltage matches that of the power re-
quired for the register.
Insert the REG key into the Control Lock.
Turn the Control Lock to the REG position.
(1) (2) (3) (5) (6) (7) (8) (4)
6
7
Install the paper roll (referring to Chapter 8. Installing the
Receipt/Journal Roll on page 12). Also, install the Ribbon
Cassette
(referring to Chapter 9. Installing the Ribbon Cas-
sette on page 15).
Before starting actual transaction entries on the register, ask
your manager if you need additional setting or the pro-
grammed data needs to be changed. For programming, refer
to the following Chapters in Manager’s Guide:
4. Changing the Programmed Data (page 17)
5. Program Data Verification (page 41)