Toshiba TEC MA-1350-1 - Manual (Page 38)

- 31 -
EO1-11126
MA-1350-1 SERIES
NOTES: 1. For entering a Dollar Discount that will cause the sale total into negative (credit balance), one
of the following can be selected (ask your TOSHIBA TEC representative):
If status “Credit Balance Prohibited” (initial status) is selected:
Over-subtraction of the sale total by Dollar Discount causes an error.
If status “Credit Balance Allowed” is selected:
Over-subtraction of the sale total by Dollar Discount is possible.
2. The [DOLL DISC] key has its own Tax (PST) Status, GST Status, and Food Stamp Status
programmed. Refer to “Tax Status Modification” (page 40) and “Food Stamp Modifica-
tion” (page 41) for reversing the status.
3. Dollar Discount can be programmed to require the MGR position of the Control Lock. If so
programmed, an error will occur on depressing the [DOLL DISC] key in the REG position. In
this case, ask the store manager to turn the Control Lock to the MGR position for the entry.
(Refer to the chapter 1. Operations in “MGR” Mode on page 1 in Manager’s Guide.)
Vendor Coupon
Sale Item Entries
. . .
Vendor Coupon
Amount
VND
CPN
An amount of $1.00 is en-
tered as Vendor Coupon.
V.CPN 1.00-
NOTES: 1. For entering a Vendor Coupon amount that will cause the sale total into negative (Credit
Balance), one of the following can be selected (ask your TOSHIBA TEC representative):
If status “Credit Balance Prohibited” (initial status) is selected:
Over-subtraction of the sale total by Vendor Coupon causes an error.
If status “Credit Balance Allowed” is selected:
Over-subtraction of the sale total by Vendor Coupon is possible.
2. The [VND CPN] key has its own Tax (PST) Status, GST Status, and Food Stamp Status
programmed. Refer to “Tax Status Modification” (page 40) and “Food Stamp Modifica-
tion” (page 41) for reversing the status.
3. Vendor Coupon Entry can be programmed to require the MGR position of the Control Lock. If
so programmed, an error will occur on depressing the [VND CPN] key in the REG position. In
this case, ask the store manager to turn the Control Lock to the MGR position for the entry.
(Refer to the chapter 1. Operations in “MGR” Mode on page 1 in Manager’s Guide.)
4. When a limit amount has been programmed for the [VND CPN] key, an amount exceeding
the limit amount cannot be entered in the REG position. However, in the MGR or - position,
the limit amount programmed is ignored and max. 7-digit amount can be entered through the
[VND CPN] key.
Store Coupon
Depress prior to or any time during the entry sequence of the following operations for Open-price
or Preset-price Departments already described:
Entry of One Department Item
Department Quantity Extension
NOTE 3
Single-item Department Entry NOTE 2
NOTES: 1. The [STR CPN] key must be pressed, at the latest, before the final key of the required
Department entry sequence.
2. The Store Coupon amount must be entered inside a sale and must not exceed the sale total
unless the “Credit Balance Allowed” option is selected. (Ask your TOSHIBA TEC representative.)
3. Quantity Extension (multiplication) is permitted with this key, but no decimal quantity will be
accepted.
STR
CPN
( )
ST