Toshiba TEC MA-1350-1 User Manual
Page 63
- 56 -
EO1-11126
MA-1350-1 SERIES
Some segment is not displayed, display shimmers, or illumination of the display is
uneven.
Cause 1:
Failure of the LED
Measure:
Ask the store where purchased.
6. Trouble during Normal Operations
NOTE on changing the Control Lock position:
Changing the Control Lock position during sales entries or programming causes an error. To clear the error,
return the Control Lock to the original position. However, changing the Control Lock position to the OFF does
not cause an error. Error caused by changing the Control Lock position cannot be cleared by the [C] key.
Normal operations cannot be carried out.
Cause 1:
Control Lock position does not correspond to the operation you attempted.
Measure:
Check whether or not the Control Lock position corresponds to the operation. (Especially, check
whether or not the operation you attempted requires the MGR position. Ask your manager about
the operations which requires the MGR position.)
Error tone beeps
Cause 1:
Operation procedure is incorrect.
Measure:
Depress the [C] key to clear the error, then check the operation procedure you attempted.
Cause 2:
Control Lock position is incorrect.
Measure:
Turn the Control Lock to the correct position using the Control Key.
Cause 3:
Operation in the REG position was attempted while the drawer remained open. (In case that the
Drawer-close Compulsory Option has been selected.)
Measure:
Close the drawer, then depress the [C] key.
7. Trouble in the REG Position
Operations in the REG position cannot be carried out.
Cause 1:
Control Lock is not in the REG position.
Measure:
Turn the Control Lock to the REG position using the Control Key.
Cause 2:
Cashier Identifying Operation was not performed when the Cashier Identifying Option has been
selected.
Measure:
Perform the sign-ON or set the Cashier Key ON. (Refer to page 17.)
Cause 3:
Operation was attempted while the drawer remained open. (In case that the Drawer-close
Compulsory Option has been selected.)
Measure:
Close the drawer, then depress the [C] key.
Cause 4:
Operation you attempted requires the MGR position.
Measure:
Depress the [C] key, and ask your manager whether the operation requires the MGR position. If
required, ask your manager to turn the Control Lock to the MGR position.
Cause 5:
You ignored the validation print when the Validation Compulsory Option has been selected to the
last operation you attempted. (In this case, the status lamp “SLP” flickers.)
Measure:
Depress the [C] key, and perform the validation print.
Cause 6:
After performing the validation print, you attempted the next operation while the validation slip
remained in the validation slot.
Measure:
Depress the [C] key, and pull out the validation slip from the validation slot.