Toshiba 37AV52U - Manual (Page 22)

Chapter 3: Using the remote control

Using the remote control to
control your other devices
If you have a non-Toshiba device or a Toshiba device that the
remote control is not preprogrammed to operate, you must
first program the remote control to recognize the device (if
you have not already done so) ( pages 24–26).
To use your TV remote control to operate a:
Cable converter box or satellite receiver, set the MODE
SELECT switch to CABLE/SAT .
VCR, set the MODE SELECT switch to AUX 1 .
DVD player or HTIB, set the MODE SELECT switch to
AUX 2 .
Note:
Even after the TV remote control is programmed, it
may not operate certain features on any other devices. If this
happens and you wish to use those features, you will need to
use the device’s original remote control.
16
17
19
18
Point the remote control
directly at the device.
•
•
•
POWER Turns the selected device on and off.
Channel Numbers (0-9) Press to directly access
channels (as opposed to ).
+10 Press to directly access DVD chapters higher than 10.
TOP MENU Accesses a DVD’s top menu.
CH pq For channels programmed into the channel
memory ( page 30):
p selects the next higher channel.
q selects the next lower channel.
GUIDE Displays the channel guide in the CABLE/SAT
mode.
SET UP Accesses a DVD’s setup menu in the AUX
mode.
INFO Displays TV status information on-screen.
pqtu Press to navigate DVD menus (may not work
on some DVD players).
ENTER Required by some satellite receivers and DVD
players to activate certain functions.
DVD CLEAR Press to reset the title and chapter number.
PLAY Begins playback of a tape or DVD.
PAUSE Press during play or record mode to pause the
picture; press again to restart.
STOP Stops the tape or DVD.
SKIP Skips forward to locate later DVD chapters.
FF Fast-forwards the tape or DVD. (Press during play
mode to view the picture moving rapidly forward.)
SKIP Skips back to beginning of current DVD
chapter, or locates previous chapters.
REW Rewinds/reverses the tape or DVD. (Press during
play mode to view the picture moving rapidly backward.)
TV/VCR To view one program while recording another,
press to select TV mode.
SEARCH selects a specific DVD chapter, title or time.
REC Starts tape recording.
MODE SELECT switch Set to “TV” to control the
TV; “CABLE/SAT” to control a cable converter box or
satellite receiver; “AUX 1” to control a VCR; “AUX 2” to
control a DVD player or HTIB.
1�
2�
3�
4�
5�
6�
7�
8�
9�
10�
11�
12�
13�
14�
15�
16�
17�
18�
19�
20�