Toshiba 37AV52U - Manual (Page 5)


Choosing a location for your LCD TV
To Display your LCD TV on the included Pedestal
Stand:
Observe the following safety precautions:
1) Read and Follow the pedestal assembly instructions included
with the pedestal.
CAUTION:
Before beginning pedestal assembly, carefully lay the
front of the LCD Panel face down on a flat, cushioned surface
such as a quilt or blanket. Leave the bottom of the unit protruding
over the edge of the surface and assemble the pedestal as
indicated below.
Note: Extreme care should always be used when attaching
the pedestal stand to avoid damage to the LCD panel.
2) Place the TV on a sturdy, level surface that can support the
weight of the TV.
3) Be sure to secure the TV to a wall, pillar, surface, or other
immovable structure. ( item 20, page 3).
To Display your LCD TV using a Wall Bracket:
If you decide to wall mount your LCD TV, always use a UL listed wall
bracket appropriate for the size and weight of the LCD TV (  page 2):
1)
CAUTION: Two people are required for installation.
2) Unplug and remove any cables and/or other component
connectors from the rear of the TV.
3) Remove the screws of the 32”/ 37” VESA Mounting Pattern
show in the right diagram.
4) Follow the instructions provided with your wall bracket.
Before proceeding, make sure the appropriate bracket(s) are
attached to the wall and the back of the TV as described in the
instructions provided with the wall bracket.
5) After attaching the appropriate bracket(s) to the wall and the
back of the TV, remove the pedestal stand from the TV as
described below.
6) VESA Mounting Pattern
TV Size Hole Pattern(VxH) Screw Size
26” 100x200 mm M4
32” 200x400 mm M6
37” 300x500 mm M6
(unit in mm)
Removing the Pedestal Stand
1) Carefully lay the front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave the stand
protruding over the edge of the surface.
Note:
Extreme care should always be used when removing
the pedestal stand to avoid damage to the LCD panel.
2) Remove the four screws shown in the right diagram. This will
allow removal of the pedestal stand.
3) Once you have removed all four screws, holding the pedestal
stand in place, remove the pedestal stand from the TV.
Always place the TV on the floor or a sturdy, level, stable surface
that can support the weight of the unit. To secure the TV, use a
sturdy strap from the hook(s) on the rear of the TV to a wall stud,
pillar, or other immovable structure. Make sure the strap is tight,
secure, and parallel to the floor.
Four screws
Four screws
6” TV
” TV
7” TV
Four screws
VESA Mounting Pattern
VESA Mounting Pattern
VESA Mounting Pattern
Hook
Sturdy strap
(as short as possible)
Hook
Sturdy strap
(as short as possible)
Hook
Sturdy strap
(as short as possible)