Toshiba 37AV52U - Manual (Page 30)

Chapter 5: Setting up your TV
0
Programming channels into the
TV’s channel memory
When you press or on the remote control or TV
control panel, your TV will stop only on the channels you
programmed into the TV’s channel memory.
Follow the steps below to program channels into the TV’s
channel memory.
Programming channels automatically
Your TV can automatically detect all active channels in your
area and store them in its memory. After the channels are
programmed automatically, you can manually add or erase
individual channels in the channel memory.
Note:
You must configure the ANT/CABLE input source before
programming channels ( page 29).
The automatic channel programming process will erases
channels that were previously programmed into the TV’s
memory.
To tune the TV to a channel not programmed in the channel
memory, you must use the Channel Number buttons on the
remote control.
Programming channels when the ANT/CABLE input is
configured for Cable will take substantially longer than
when the antenna input is configured for
Antenna
. This is
normal; however, once channel programming is finished,
you should not have to repeat the programming process
again unless your Cable TV service lineup changes
significantly.
To program channels automatically:
Configure the antenna input source, if you have not
already done so ( page 29).
Press and open the
Setup menu.
Highlight
Installation and press .
•
•
•
•
1�
2�
3�
(A new set of
Installation menu icons will appear, as
shown below.) Open the
Terrestrial menu, highlight
Channel Program to bring up the Start, and press
again to begin channel programming.
The TV will automatically cycle through all the antenna
channels, and store all active channels in the channel
memory. While the TV is cycling through the channels,
the message “Scanning channels, please wait” appears (as
shown above).
To cancel channel programming, press on the remote
control (or highlight
Cancel in the on-screen display and
press ).
When channel programming is finished, press or to
view the programmed channels.
Manually adding and deleting channels in
the channel memory
After automatically programming channels into the channel
memory, you can manually add or delete individual channels.
To add or delete channels in the channel memory:
From the
Setup menu, highlight Installation and press .
A new set of
Installation menu icons will appear.
Open the
Terrestrial menu, highlightChannel Add/
Delete, and then press .
To add a channel to the channel memory:
Highlight the unchecked box next to the channel number you
want to add, and then press
to check the box.
(continued)
4�
5�
1�
2�